If you are getting windows stop error message when the Emulex Elxsli2.sys driver is installed in your computer then you may receive so many stop error codes messages in this error. Just like you may get “STOP: 0x00000019 (0x00000020, 0xfd6c6290, 0xfd6c62d0, 0x0a080001) BAD_POOL_HEADER” error message or “STOP: 0x000000D6 (0xebf65002, 0x00000001, 0xf37c7089, 0x00000000)” error message. There are also so many error codes like STOP: 0x000000C2, STOP: 0x0000000A occurs when you face windows stop error.
The process to fix windows stop error message is available in this content by which you can fix the all windows stop error messages easily but it’s before you should have to know why you are getting the windows stop error message after installing the Emulex Elxsli2.sys driver, the reasons are given as below.
Causes of getting windows stop error message
The windows stop error messages may generate when the Emulex HBA (host bus adapter) driver (Elxsli2.sys) is connected to the EMC storage area network and this is the exact reason of occurring the error. You can fix this error by applying the process on your computer that is given in the below paragraph.
Solution of windows stops error
To fix the windows stop error message you have to disable the Elxsli2.sys driver on your computer. To disable it you have to use the recovery console. To do this first of all you have to configure the computer to boot from the cd that means you have to change the boot priority order and set the cd drive as first boot and save the changes. After then insert the windows server 2003 cd into the cd drive of your computer and then restart your system. When you will see the message press any key to start from the cd then you have to press any key from the keyboard. It ensures that the message is displayed for a few seconds so don’t wait. You will see the welcome to setup screen appears in your computer then press R from the keyboard to start the recovery console and then type the administrator password if prompted then press enter. After that type disables elxsli2 in the command prompt and then press enter. Then type exit to exit from recovery console and restart the system. After restarting the system you will not face the windows stop error message in your computer.