You might be using windows operating system from long time and you want to install new windows operating system over in it and you try to install but you failed. A big error message is showed up in front of you error 0x0000007a or kernel data inpage error. Kernel data error 0x0000007a happens when you try to install the windows 2000 in intelligent drive electronics (IDE) or ultra DMA66 or ATA 66 computer.
0x0000007a dismays some different types of error also, they are like: “stop 0x0000007a kernel_data_inpage_error address####has base at ******-atapi.sys”. This error is very critical because if you do not solve it quickly then it might causes some big problem to your system like you may lose your data, hard drive corruption, hardware missing and so on. Windows 2000 is very power full operating system because it is server based operating system. server based operating system specially designed by Microsoft. Server based operating system run on the server but simultaneously using the micro processer. This is only in windows not in other server based operating system.
Causes to get the error 0x0000007a:-
If you are using the ultraDMA66 or ATA 66 IDE cables (80wires in 40 pin) which is attached with your drive and you installing the windows 2000. If your ultraDMA 66 cable is not supporting the windows 2000. If your atapi.sys is missing or corrupted. In case your system settings might be changed. If your windows 2000’s registry file is missing or corrupted. If dll files are missing or corrupted when you installing the windows. Is your system is full of virus, malware or Trojan.
How to solve the 0x0000007a, for that need to perform some manual steps which are given below:-
If you are using the ultraDMA66 or ATA66 IDE cables(80 wires in 40 pin) which is attached to your drive then change the wire and with that your mother board also then it might possible to install the windows 2000. Check your ultraDMA66 supporting the windows or not, if not then change the cable or don’t install the windows 2000. Check in the windows32 file for the atapi.sys is missing or corruption, there is any problem then try to update your system. If your system settings are changed then change it as default. If your registry file is missing or corrupted then try to update it or restore it. In case your dll files is missing or corrupted then try to restore it. Scan your computer for virus, malware or Trojan, if you find any of them then delete it.
All the above manual steps did not work then try to get help from third party tool. third party tool solve your problem automatically. Third party tool is very easy to use. This tool handled by anybody, even kids also handle it. Third party tool is very trustworthy and secure for use.